Main > Main Forum
Just got my Ultimarc trackball.
<< < (2/2)
paigeoliver:
Actually, instead of trying to make the holes slightly bigger to accomodate the lips on my trackballs I am just going to sand the lips off of them, it is a lot easier to sand down some plastic than it is to make a hole in metal 1/4" bigger.
Zakk:
I guess the only issue would be it might be easier to shake the bolts loose since it wouldn't be 'locked' into the hole.  I mention this because I've installed a few of these trackballs and I don't know how they would take to being bolted in REALLY tight. (the tops of the bolt hole sleeves come off as I recall).  At the very least use really good locknuts or lockwashers.
Navigation
Message Index
Previous page

Go to full version