Main > Monitor/Video Forum
Vision Pro went bad?
limiter:
Hi, I just bought a Vision Pro VGA/SVGA horizontal mointor from Happ Controls. I plug it in and try to use it and the mointor just clicks and I get no picture. I assume this means the monitor is dead? Thanks for input.
SteveJ34:
I believe the max res for the monitor in question is 800x600.
Is it possible the system you're connecting it to for testing is perhaps set to something higher?
Just a thought...
limiter:
I thought of that also, but when the Motherboard is first powered on it should be displaying in 640x480. The system was initially setup for 640x480 anyways. There is no monitor flash when I power it on either, just clicks.
When I say "clicks" I mean not just once, but in repetitive forever sort of way.
limiter:
In case anyone cares, the Happ Controls tech support said the monitor was clicking because the power supply was repeatedly powering down and starting up.
Ken Layton:
The power supply is shutting because a short circuit somewhere. Is it possible a screw or piece of metal could have landed on the circuit board during shipping? Is the circuit board in good physical condition and did not crack during shipment?