| Main > Main Forum |
| (sigh) That's the way the laptop crumbles. |
| << < (3/3) |
| Witchboard:
I don't think the glue will work. The runs are too fine. I would prefer either to get a new cable or not use it at all and maybe sell the TFT display to somebody who needs one. |
| paigeoliver:
As far as careful soldering, I didn't mean solder on the ribbon cable, I meant solder jumper wires inbetween the locations the ribbon cable connected. You need a steady hand and thin wire, but it is doable. It would be a lot easier than replacing the surface mount bios on a newer neo geo board (which I have seen a lot of people do). |
| Witchboard:
I really don't think it's possible to solder these. I'll take a picture of the connections and you all can give me your opinions. I can do cap kits and replace ram chips and stuff, but this is too small for me. |
| ShinAce:
You just need a finer tipped iron and a magnifying glass, :P. I'd go with a new cable myself. |
| Navigation |
| Message Index |
| Previous page |