Main > Main Forum

can this stick modd?

Pages: << < (2/3) > >>

oldsage:


--- Quote from: alundra on March 06, 2005, 02:31:02 pm ---i dont like the ball top joystick, im not used to it...

--- End quote ---

With ya, it feels very unnatural for me too...

alundra:


--- Quote from: spiffyshoes on March 06, 2005, 03:45:24 pm ---Happ joysticks won't fit.

--- End quote ---

can you be more specific, is it because the case is too thin or the screw holes doesnt fit with happ joystick? if its the holes can you just drill the holes on happ joy so it will line up with the holes on the case? thanks

tmasman:

Because a Happ stick needs a little more than 2" of space below the panel...
I bet you that the stick you're looking at isn't even that thick, let alone would it have 2" of free space inside after removing the existing stick...

Most of these sticks & buttons are not anything like the arcade originals... They have PCBs with contact points on them (more like game pads)...

But you WILL NOT be able to put a Happ stick in that case... (well... not without a serious mod & adding a new bottom...)

alundra:

im pretty sure its over 2 inches..i might rip all the button and joystick out..or buy a sanwa joystick to replace in...

JB:


--- Quote from: tmasman on March 06, 2005, 06:33:30 pm ---Because a Happ stick needs a little more than 2" of space below the panel...
I bet you that the stick you're looking at isn't even that thick, let alone would it have 2" of free space inside after removing the existing stick...

Most of these sticks & buttons are not anything like the arcade originals... They have PCBs with contact points on them (more like game pads)...

But you WILL NOT be able to put a Happ stick in that case... (well... not without a serious mod & adding a new bottom...)

--- End quote ---
The japanese are a lot better about using proper switched controls in their arcade sticks than the US manufacturers.

I can't speak for this specific device, though.

Pages: << < (2/3) > >>

Go to full version