Main > Main Forum

Getting ready to build

Pages: (1/4) > >>

bicho:

Today I finally decided to order the parts I need to make the control panel.
I am a little sceptical on how to put all these thing together and that I have everything I need.

This is what I ordered.

(3) 4-8 way comp. joysticks
(8) push buttons.  I already had 18 from a friend that works with electrical stuff, and they happen to be happ's.
(1) 3" trackball
(1) oscar spinner
(1) hangstrong trackball/spinner encoder
(1) Keywiz keyboard encoder

Is there anything I need to order?  I had in mind to install a light gun but it's getting to expensive right now, perhaps in the future I will consider it again.



JODY:

Depends...

Did you want to use any t-molding around the outside edge of the control panel?

I'd use some .187 wire connectors on the sticks and buttons to prevent soldering.

GGKoul:

One note..

The Comp joysticks you order one works in a 8 way or 4 way mode.  There is no quick way to switch from 8 to 4 way mode like a T-Slik Plus.



tommy:


--- Quote from: GGKoul on March 03, 2005, 11:12:18 pm ---One note..

The Comp joysticks you order one works in a 8 way or 4 way mode.
--- End quote ---


mahuti:

If your panel is wood, you'll need a trackball mounting plate.

Pages: (1/4) > >>

Go to full version