| Main > Main Forum |
| Simple question about t molding... |
| << < (3/3) |
| Nocturnaloner:
--- Quote from: fredster on March 01, 2005, 11:21:43 pm ---That t molding bit is about $35 bucks too. --- End quote --- It can be had, with the arbor, for 16 bucks shipped at the mcls site liked above. |
| thedyingmatt:
Ouch, well I've already assembled my bartop and am now in the cosmetics stage of the job, and just now decided to go with some t molding. Does this mess me up pretty good?? Can I still apply with cab together?? It is a bartop so I don't even know if it's a good idea to add it, but I think it is seeing as I recessed the top panel a bit to give it the real arcade feel. Upon looking closely, I'm guessing it's going to be difficult to put the molding on an already assembled bartop, but any advice would be appreciated!! Matt |
| Goz:
You could cut the tmoulding so it could lay flay against the wood and then glue it. It would be possible to do a clean enough job that it wouldn't be noticeable. I did it once with a cocktail and it came out pretty ok. -Goz |
| fredster:
I was never good at precision cutting with a razor. :'( But if you do this t slot right with a router, you can put it in less than 5 minutes per side. |
| Navigation |
| Message Index |
| Previous page |