Arcade Collecting > Miscellaneous Arcade Talk
Best and safest way to clean up PCB's and Monitors?
Wyluli:
--- Quote from: tommy on February 28, 2005, 07:38:41 pm ---I take some qtips and go threw the board a few times till clean
--- End quote ---
Damp q-tips or wet? With water or alcohol?
fredster:
There's a tutorial on this at mikesarcade.com
SirPeale:
Preheat your oven to 200 degrees. Then turn it off. Take the board to the sink. Spray it down. Spray the board with degreaser. Let it sit for a couple minutes, then *gently* scrub with a soft brush. Rinse well. Take a blowdryer to it on high air and get as much water off as possible. Then put the board in the oven. Come back in a few hours.
D_Zoot:
--- Quote from: Peale on March 02, 2005, 11:13:27 am ---Preheat your oven to 200 degrees.
--- End quote ---
SirPeale:
Just the one, and it worked fine.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version