Main > Main Forum

t-moulding

Pages: (1/2) > >>

sodapopinski:

I just found a router bit that will cut the groove for t-moulding. What size is the kerf suppose to be? the bit is about 1/8".


TalkingOctopus:

1/8" is too big.  It needs to be 1/16".  Many people, including myself ordered a bit here:

http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_slot.html



stellarola:

They also sell the same bit at Lowes.

Jabba:

You can also special order a 1/16" Freud bit (the best) at Home Depot. Its Called a Freud 1/6" Slot Cutter...

FractalWalk:

Am I the only one that used 3/32". That worked perfectly for me. It holds tight but still lets me remove it without taking a pound of MDF with it.


Pages: (1/2) > >>

Go to full version