| Main > Main Forum |
| Operation Wolf help |
| (1/1) |
| killbill:
Hi, I just recently purchased an OPeration Wolf cab. The game worked, but the coin switches would not register credits. So, I checked continuity all the way to the jamma plug. All was good. So, I removed the Jamma plug from the main board and bent a few of the connectors to make better contact. I plugged it back in and fired up the machine. \ Good news: Coin slots works. Bad News: The monitor has become just blue wavy lines. This is the point when I did something really stupid. I started messing with all of the picture adjusting knobs in the back of the monitor. There are about eight of them. I messed them all up. Later I realized that by messing with the monitor wires that were running into the jamma plug, the picture would get a little better. So, I'm going to pick up a new Jamma connector and re wire it; but that leaves the monitor and the adjustment knobs being so far out of whack that even if the jamma plug was working great, I still wouldn't see a clear picture. Is there any way to reset the knobs on the back of the monitor, and start from scratch to adjust the picture. I honestly messed with it for two hours and couldn't get close. Any info is truly appreciated. Thanks. |
| RayB:
Move them all to the half-way point. You can probably go from there.... |
| Navigation |
| Message Index |