Main > Main Forum
To plexi or not to plexi...that is the question.
<< < (5/7) > >>
JODY:

--- Quote ---Now, where to find inexpensive black anodized 3/16" (or #10-24) carriage bolts?

--- End quote ---

Best place I know of is Bob Roberts - www.therealbobroberts.com
CoinTech:
You might ask for polycarbonate plastic.
krick:

--- Quote from: spystyle on February 09, 2005, 06:01:44 pm ---Were you drilling in reverse?

--- End quote ---

I first saw that reverse drilling technique in the case mod community.  People adding side windows to their cases.

They also say to buy a cheap drill bit, chock it up in the drill, and drill it into a concrete sidewalk to dull the point as well.  THEN also run it in reverse.
Scanner:
Go with the plexi overlay.
ALeX K:
That looks cool. Could you tell me how you deal with the edge condition and how you protect where the plexi stops at the CP edge? I can't quite see in those photos... is it all just covered with T mould? Is there a clip? I am interested in doing a CP like this with no visible top fixings (I have heard that the buttons and sticks can hold down the plexi a fair bit), but would really welcome any advice on a neat way to achieve this with a neat edge condition....

Thanks!
Navigation
Message Index
Next page
Previous page

Go to full version