Main > Main Forum

New Product - V2 spinner & Push Kit

Pages: << < (16/19) > >>

spiffyshoes:

I couldn't wait to play with my new Spinner so I made a temp. controll panel out of the box it came in.

NoOne=NBA=:


--- Quote from: spiffyshoes on February 18, 2005, 01:24:13 pm ---I made a temp. controll panel out of the box it came in.   :)

--- End quote ---

I told you to build a modular CP.
All I did was rip a flightstick hack I don't use anymore out of ITS module, and stuff the V2 into it.

sWampy:

Finally got mine hooked up, great spinner.   One small improvement might be a way to mount the encoder on the other sides where the spinner could fit in a little bit tigher spaces.  Since the mounting ears already stick out  3.4 inches, and the encoder board is almost 3 inches, you could fit the spinner in a 3.4x2 inch space, rather than 3.4x3, if the encoder was just attached to the wide side.

KevSteele:

VERY, VERY Cool...

Good job!



RayB:

Oscar, I tried ordering the box that Spiffyshoes used, but it's not on your order page! how do I order it?





Pages: << < (16/19) > >>

Go to full version