| Main > Main Forum |
| New Product - V2 spinner & Push Kit |
| << < (16/19) > >> |
| spiffyshoes:
I couldn't wait to play with my new Spinner so I made a temp. controll panel out of the box it came in. |
| NoOne=NBA=:
--- Quote from: spiffyshoes on February 18, 2005, 01:24:13 pm ---I made a temp. controll panel out of the box it came in. :) --- End quote --- I told you to build a modular CP. All I did was rip a flightstick hack I don't use anymore out of ITS module, and stuff the V2 into it. |
| sWampy:
Finally got mine hooked up, great spinner. One small improvement might be a way to mount the encoder on the other sides where the spinner could fit in a little bit tigher spaces. Since the mounting ears already stick out 3.4 inches, and the encoder board is almost 3 inches, you could fit the spinner in a 3.4x2 inch space, rather than 3.4x3, if the encoder was just attached to the wide side. |
| KevSteele:
VERY, VERY Cool... Good job! |
| RayB:
Oscar, I tried ordering the box that Spiffyshoes used, but it's not on your order page! how do I order it? |
| Navigation |
| Message Index |
| Next page |
| Previous page |