Main > Main Forum

Counter-sink v.s. double drilling.

Pages: (1/3) > >>

jbox:

Just a quick question:

Is there a huge difference between using a counter-sink drill bit and triangular head screws, as opposed to just double-drilling a hole (thin through, thick just a few cms) and then using a square headed screw.

I can't believe getting a perfect triangular match adds any real difference to the grip, compared to actually getting some good wood and a good thread.

Tailgunner:

Not a huge difference. It's more of a speed/ease of assembly thing,  as using counter sunk screws eliminates the extra drilling step.

NoOne=NBA=:

Unless you plan to use a forstner bit, the bottom of the hole isn't going to be flat anyway.
A regular bevel tipped drill bit is going to leave a 45 at the bottom of the hole.

mjrsting:

Kinda depends on the material you're using.

rockhopper:

I counter-bored (double drilled) most of the holes in my mdf cab, and it is rock solid.


Pages: (1/3) > >>

Go to full version