Main > Buy/Sell/Trade - non-retail
Any interest in these?
spiffyshoes:
Oh I see I guess tilting it like that would elliminate one of the angled cuts. How much extra would it cost to get that extra angle cut? I kind of like it butter with the back straigh up and down but if it would cost to much extra then angleing it like that would be ok.
usedelectronics:
The rear panel isn't tilted. I just made a 3/4" Straight section at the very back. That way the top of the rear panel doesn't need to be angle cut.
The notches on the buttons mmay be possible, but they cant have straight inside corners. The minimum radius is 1/4"
So it would have to be a 1/4" wide slot with a rounded end.
If you could send me, or post a image of the dimensioned joystick/button layout, I could add it to the model.
(I had a mistake on my top panel, as I feared.. It doesnt have the gap anymore.... ::))
tmasman:
So is this your CNC router, or one you have access to at work?
I've been collecting parts to make my own, & was just curious.
- tmasman
AmericanDemon:
BYOCNC? Thatd be intense.
tmasman:
--- Quote from: AmericanDemon on February 19, 2005, 10:33:13 am ---BYOCNC? Thatd be intense.
--- End quote ---
cncZone.com
It is...
But it's another thing I really don't have time for, but REALLY want to get into.
I've been collecting the parts to build a small one (12" X 12") to see if I can feasibly build one myself with the tools I have.