| Main > Main Forum |
| please please help! |
| << < (3/3) |
| Jabba:
--- Quote from: colonel_colon on January 19, 2005, 11:22:59 am ---Has anyone experienced any problems with cutting the plywood with veneer already attached? --- End quote --- A trick I learned when cuting plywood or something with a veneer is to tape over the cut with masking tape on the good side. Then just cut the wood as you normally would. This will prevent tearout and will produce a nice clean cut. Also, make sure you are using the right blade (ask somone at Home Depot) and that the blade is sharp and in good condition. A melamine blade has something like 50 teeth and produces a very fine cut, whereas a cross-cut blade has something like 24 teeth and produces a very rough cut. The more teeth, the finer the cut. |
| Navigation |
| Message Index |
| Previous page |