Main > Main Forum
Looking for a dado cutter for my router
<< < (2/2)
Mameotron:

--- Quote from: DrewKaree on January 17, 2005, 11:43:30 pm ---Use Gorilla Glue to REALLY fill the gap.

--- End quote ---


Absolutely right on.
DrewKaree:
Ya, but not TOO much.  It'll even spread the clamps apart if you put TOO much in there. don't ask how I know that
Tailgunner:

--- Quote from: DrewKaree on January 18, 2005, 12:08:07 am ---Ya, but not TOO much.  It'll even spread the clamps apart if you put TOO much in there. don't ask how I know that

--- End quote ---

Heh, Gorilla Glue is basically very low expansion polyurethane foam. Concidering how long spray foam cans have had "Caution, non-removable from most surfaces, including you" warnings on them, it's surprising nobody figured out the stuff would make a good glue.

As to how much force the stuff can exert, I've seen the corner of a house lifted off of it's foundation by an overzealous application of spray foam.
Navigation
Message Index
Previous page

Go to full version