| Main > Main Forum |
| Has anyone had an issue with oversized disconnects? |
| << < (2/3) > >> |
| Sephroth57:
if theyre non insulated, i would either crimp them down or just throw a dab of solder on them |
| crashwg:
I had to tap every single one of mine with a hammer to get it to a tension I thought was acceptable... It was as simple as tap-tap, check fit, tap-tap... |
| HaRuMaN:
The ones I got from Peale were somewhat loose, I had to squeeze them a bit to make them tight. |
| Trimoor:
I gave up on quick connects and just soldered the wire to the switch. Its much faster and easier. I wish I did it earlier. |
| versapak:
--- Quote ---I gave up on quick connects and just soldered the wire to the switch. Its much faster and easier. I wish I did it earlier. --- End quote --- Until you have to replace one. It takes all of one second to pinch the quick connect a little with a pair of pliers. Quick connects are not all going to be open the exact same amount to start with anyway. It is not like they are a highly tuned pieced of scientific equipment. We are talking mass produced, bulk packaged, little pieces of light metal that slides over another piece. Not much harm can be done in a little pinch. |
| Navigation |
| Message Index |
| Next page |
| Previous page |