| Main > Main Forum |
| miniPac - can you hook up a trackball AND spinner? |
| (1/1) |
| megashock5:
Hello, I'm going to be using a miniPac for my interface and I already have the trackball. I'm trying to decide if I'm ambitious enough to attempt building a spinner. However, before I start I want to make sure both can run off of one miniPac. If not, looks like I'll make do with just the trackball. thanks! |
| vputz:
I have a miniPac (and love it); you can indeed connect a trackball and spinner simultaneously, but you can NOT use them both at the same time. The minipac is switched; if you move the spinner, trackball motions are not registered at all until you leave everything motionless for a bit (and then moving the trackball disables the spinner, etc). -->VPutz |
| sWampy:
Make sure you talk to Andy before buying one with out a wiring harness, he said the new boards bought without wiring trackball wiring harness wouldn't support trackball or spinner. |
| megashock5:
I bought in the fall, but I did buy it with the wiring harness. So hopefully I'll be okay. Is it hard to connect both (spinner and trackball) to it? |
| vputz:
Dead easy... provided you get the right trackball/spinner (in other words, if you bought a Happ/Vortex cable, buy a Happ trackball and a Vortex spinner). You'll have two cables to the harness--one for the TB, one for the spinner. Plug and go. However, I do recall being confused about how to plug one of them in, but I don't remember what the specific problem was... so there may be some confusion. Bleah, curse my fading memory. It worked out fine, though. -->VPutz |
| Navigation |
| Message Index |