Main > Monitor/Video Forum

Pincushion problem with wells monitor

<< < (2/5) > >>

hiperco:

A couple of observations. 

-I don't think that barcode in picture #1 is the chassis model number.  It should be something like 25K7184 (for example).  (By chassis I mean the circuit board in the back, not the tube etc)

-Are you sure that a cap kit has been installed?  And it was the correct one for your monitor? 

mamerocks87:
I think this is what your wanting....
 Tell me if its not



27k7401

Yes there are new caps on it, however i didnt put them in so I can not say for sure if they were for the right monitor.  Im almost positive they would be because it was a reliable seller.   Thanks,

-Kyle

hiperco:
Thats the one  8)

Now for a guru to chime in and give you some expert advice.

Ken Layton:
The k7400 series is a current production model. I don't think there's a capkit released for this model yet. I agree that your pincushion problem is pretty bad. I don't have a schematic or service manual for any sizes of the k7400 series. It might be a good idea to phone the tech support department at Wells-Gardner about this problem.

mamerocks87:
What all do i need to ask them?

-Kyle

Navigation

[0] Message Index

[#] Next page

[*] Previous page