Main > Main Forum
Drill bit size for pushbutton and joystick holes?
DrewKaree:
--- Quote from: the3eyedblindman on December 31, 2004, 12:00:51 am ---
question in thread title.
--- End quote ---
answer in search button
leafblade:
--- Quote from: versapak on December 31, 2004, 12:03:20 am ---1 1/8"
--- End quote ---
What is this size in mm?
pointdablame:
--- Quote from: leafblade on December 31, 2004, 12:24:29 pm ---
What is this size in mm?
--- End quote ---
(1 1/8) inches = 28.57500 millimeters
Doesn't anyone know how to use google? sheesh
leafblade:
--- Quote from: pointdablame on December 31, 2004, 12:28:59 pm ---
--- Quote from: leafblade on December 31, 2004, 12:24:29 pm ---
What is this size in mm?
--- End quote ---
(1 1/8) inches = 28.57500 millimeters
Doesn't anyone know how to use google? sheesh
--- End quote ---
before I posted the question I did go to manufacturer websites but couldn't find the conversion
thanks for the conversion even though it is a bit too accurate. I just wanted to know the drill bit needed
So will either a 28mm or 29mm be okay?
pointdablame:
I remember this coming up before on this board, and IIRC, I think ppl used a 28mm bit and the buttons fit nice and snug. Try to do a search here to see if you can find the thread, but I think that's what they found.
And to anyone else that wonders if you google " 1 inch to millimeters" or anything in the form of "first measurement TO second measurement" it'll convert it for you.
It does money, distance, weights, etc etc