Main > Main Forum

Mounting Glass over Bezel

Pages: << < (2/2)

SteveJ34:

Another approach some have taken for custom built cabs is to route a slot at the top which is usually the speaker shelf under the marquee and a similar slot in the bottom ledge.

You make the slot slightly deeper in the top and cut the glass or plexi height in such a way so that when fitting into place you can lift it up into the top slot then set it in place in the lower slot.

I didn't have the forethought when constructing mine to plan for this need so was going to just add a small frame around it or a piece at the top and bottom. However, my cab doesn't move around so I once I set it in place, I never added anything to hold it there, it's own weight and tight fit does that just fine.



ras2a:


--- Quote from: somunny on December 09, 2004, 11:54:22 pm ---Depending on your cabinet, you may just be able to let it rest against the bezel and let the weight of the glass hold it in place.

Coop

--- End quote ---

precisely what I'm planning to do.  The angle and weight of the glass should be such, that no 'retaining' method is required to secure the bezel in place.

Craig

somunny:

I suppose it all depends on how 'agressively' you play.  ;)

Coop

Hoagie_one:

the angle on my cab is such that i only have a clip on the bottom and rubber on teh 4 corners for padding and no slip action

Chris:

On my cab, which is originally a Super Contra cab, the class slides behind the speaker panel and at the bottom is wedged in place by the control panel.

Pages: << < (2/2)

Go to full version