| Main > Main Forum |
| controller for quadriplegic |
| << < (35/82) > >> |
| Tiger-Heli:
--- Quote from: SeaMonkey on December 20, 2004, 03:13:21 pm ---Most of the MAME stuff his box will run will be joystick and a button or two anyway. What is the Mame version of choice for low end machines by the way? I will make sure to hook him up. --- End quote --- MameWorld Link I would say at least go back to 0.53 when 8-bit modes were still supported. R37B15 was a Windows Build and has hardware stretching. R36B12 or previous for BattleZone, Asteroids Deluxe, etc. but this is DOS-based and harder to configure. |
| saint:
Status: $470 in donations, $50 pledged. Also, Game Cabinet's Inc. (http://www.gamecabinetsinc.com/) has quietly contacted me to let me know they will supply all the arcade parts necessary for this project, up to a maximum of $400! The parts must come from Happ Controls. Awesome! Spent status: $17 to SeaMonkey (expenses + PayPal fee) --- saint |
| RetroJames:
--- Quote from: saint on December 20, 2004, 03:59:09 pm ---Status: $470 in donations, $50 pledged. Also, Game Cabinet's Inc. (http://www.gamecabinetsinc.com/) has quietly contacted me to let me know they will supply all the arcade parts necessary for this project, up to a maximum of $400! The parts must come from Happ Controls. Awesome! --- saint --- End quote --- WOW! |
| Hiub1:
Holy Smokes! That is awesome. 1hookedspacecadet do you have any new plans after seamonkey's visit? If you would like, you can send me some of the plans and I can start on some of the basic construction of this thing. Let me know, and again keep up the good work guys! Thanks, Fred. |
| RetroJames:
--- Quote from: Hiub1 on December 20, 2004, 06:50:59 pm ---Holy Smokes! That is awesome. 1hookedspacecadet do you have any new plans after seamonkey's visit? If you would like, you can send me some of the plans and I can start on some of the basic construction of this thing. Let me know, and again keep up the good work guys! Thanks, Fred. --- End quote --- Not yet. I am waiting on SeaMonkey to send the drawings, then I can setup the model. I think we should do a full-scale cardboard or foam board mockup though and send it out for Sean to try before building to make sure we have it all setup correctly. I know I can't be sure about a cp until I put my hands on it. |
| Navigation |
| Message Index |
| Next page |
| Previous page |