Main > Main Forum
Anyone have any ideas on how to make easily Interchangable metal CP's?
<< < (3/3)
Stingray:

--- Quote from: Minwah on December 09, 2004, 04:36:55 pm ---I use similar clamps to Stingray, but I have a large front door which is easier for me to use for access than the coin door.

--- End quote ---

Mine has the wide Midway coin door, so it's actually not a problem accessing the clamps through it. Plenty of room. I could see how it might be difficult if you had a smaller coin door, especially if it were offset to one side like the coin door in the cab you pictured.



-S
NIVO:
i too am using thumbscrews hoagie. 5 to be exact. All i did was use threaded inserts into the wood behind the control panel(and like said above, all panels will have the same size). Works well so far.
Hoagie_one:
got any pics of that for reference?
Minwah:

--- Quote from: Stingray on December 10, 2004, 09:38:37 am ---Mine has the wide Midway coin door, so it's actually not a problem accessing the clamps through it. Plenty of room. I could see how it might be difficult if you had a smaller coin door, especially if it were offset to one side like the coin door in the cab you pictured.

--- End quote ---

Exactly...my door is quite small and as you say the offset doesn't help!
NIVO:
ok hoagie, here are pics of the insert in the wood, and the 2nd pic shows the actual part #, I picked these up at menards, but you could probably get them elsewhere as well

last pic shows my panel, notice the 5 small holes(1 on either corner up top, 3 across the bottom) pc thumb screws are a perfect fit. Will take about 15 seconds to change a panel. About as simple as you can get and works really really well.
Navigation
Message Index
Previous page

Go to full version