Main > Meet-Up
Calling all Aussies . . .
<< < (10/16) > >>
HoopstarsGarage:
Spriggy (or anyone else)

Can you give me the number of the place you buy your T-molding from in Perth?

Also can someone advise what size slot cutter is needed for the T molding - OzStick say 2.4mm -  3.0mm and no more than 15mm deep but every place I ring say the slot cutter is approx 50mm in diameter, therefore you'd get around a 25mm deep slot..??

And as for cars... I have a HR that I've done up a little bit - check it out HERE...


Hoops
OzStick:

--- Quote from: Virgil Tracy on May 14, 2005, 06:47:18 pm ---For all the aussie on the lists a new Australian based forum has started at http://218.214.97.249/cgi-bin/yabb2/YaBB.pl. I have posted a link for BYOAC as well as many of us have relied upon this site to get us started.

--- End quote ---

Good to hear - I will now start hanging out at a "local" forum and make myself better known!!!
spriggy:

--- Quote from: HoopstarsGarage on June 03, 2005, 12:40:09 am ---Spriggy (or anyone else)

Can you give me the number of the place you buy your T-molding from in Perth?

Also can someone advise what size slot cutter is needed for the T molding - OzStick say 2.4mm -
--- End quote ---
OzStick:

--- Quote from: HoopstarsGarage on June 03, 2005, 12:40:09 am ---Spriggy (or anyone else)

Can you give me the number of the place you buy your T-molding from in Perth?

Also can someone advise what size slot cutter is needed for the T molding - OzStick say 2.4mm -
--- End quote ---
HoopstarsGarage:
I was over at my cabinet builder mates house this afternoon and asked him - he rang up his supplier (can't remmeber the name atm) and order some black 20mm T-molding for $2.00 per metre plus GST ($2.20).  So it isn't that much cheaper than somewhere like Ozsticks.com - He is also hooking me up with a slot cutter to borrow so at least I don't have to buy one.

Priced a slot cutter at Flintware tool supplies here in Adelaide and was $52 each..!! :o

The 20mm T-molding is way bigger than I need (16mm MDF) but he said it was common practice to cut it down..

There is also a Galvins here in Adelaide..
Navigation
Message Index
Next page
Previous page

Go to full version