Main > Main Forum
Enlarging mounting holes on the I-PAC board
<< < (2/2)
paigeoliver:
I used a drill bit and spun it with my fingers, it didn't take long and then there was no chance of a slip up.
NoOne=NBA=:
Foam sticky tape works really well for most applications, as well.
Lilwolf:
buy..

smaller..

screws..

or use nails.. or use tape... or use mirror clamps..

but why drill on a $50+ item just to save a 10c screw?  Just too much of a chance to really really get pissed at yourself.

btw, I like the idea of mounting them in an old vhs plasic box... and screw that into the cabinet.  help protect them.
DYNAGOD:

--- Quote from: Lilwolf on December 06, 2004, 02:51:32 pm ---buy..

smaller..

screws..

or use nails.. or use tape... or use mirror clamps..

but why drill on a $50+ item just to save a 10c screw?  Just too much of a chance to really really get pissed at yourself.

btw, I like the idea of mounting them in an old vhs plasic box... and screw that into the cabinet.  help protect them.

--- End quote ---

great idea!!
ive had a mounting problem with my J-pac.
the egret cabinet is all sheetmetal so theres no where to screw it into and to add insult to injury, resting it on the metal could cause a short.
ill give that shot tonite!
Navigation
Message Index
Previous page

Go to full version