| Main > Main Forum |
| 1/2" or 3/4" CP? |
| << < (2/3) > >> |
| paigeoliver:
--- Quote from: captainpotato on November 29, 2004, 08:24:01 am ---It depends on the joystick you are using. I found that I had to route out my CP from underneath for a J-Stik - if I didn't, it sat way too low with 3/4" plywood. I gather that other joysticks have longer shafts so this may not be a problem with them. --- End quote --- Thats because the j-stick was designed for metal panels, not wooden panels. If you use the correct joysticks for the correct applications then you don't have to route anything. |
| HaRuMaN:
--- Quote from: paigeoliver on November 29, 2004, 08:37:24 am --- --- Quote from: captainpotato on November 29, 2004, 08:24:01 am ---It depends on the joystick you are using. I found that I had to route out my CP from underneath for a J-Stik - if I didn't, it sat way too low with 3/4" plywood. I gather that other joysticks have longer shafts so this may not be a problem with them. --- End quote --- Thats because the j-stick was designed for metal panels, not wooden panels. If you use the correct joysticks for the correct applications then you don't have to route anything. --- End quote --- Burrrrrrn! :police: |
| captainpotato:
--- Quote from: paigeoliver on November 29, 2004, 08:37:24 am ---[Thats because the j-stick was designed for metal panels, not wooden panels. If you use the correct joysticks for the correct applications then you don't have to route anything. --- End quote --- Perhaps, but as routing out a few mm is no work at all, I'd much prefer to do that than to get a joystick that wasn't *exactly* what I wanted... |
| Tiger-Heli:
--- Quote from: Apollo on November 29, 2004, 03:07:20 am ---Firstly what is your CP made out of? Secondly it should be fine, in fact better tan 3/4 as you will get better height out of your joysticks. --- End quote --- Agreed, another point is if you are going to add Lexan (plexiglass, etc.) to your CP, that will add about another 1/8" so you will effectively be at 5/8-inch. . . |
| eyal8r:
Right- should've mentioned that. I DO plan on adding plexi. Also, I am using Ultimarc's T-Stick Plus and their E-Stick, as well as a spinner and TB (not sure which ones yet). So, with this info, am I ok, or, do I need to recut the CP top? Thanks D |
| Navigation |
| Message Index |
| Next page |
| Previous page |