Main > Main Forum
New Product: Versa-Ball Joystick Replacement Shafts
<< < (13/20) > >>
Stingray:
I'm looking at ordering a pair of these to fit a set of Supers. Not sure what length I need. They're going in a metal control panel, so am I correct in thinking that I need the shortest stick (1 1/4)? Why is it that the shiny ball tops only come in 1 3/8?

-S
RandyT:

--- Quote from: Stingray on January 13, 2005, 09:34:03 am ---I'm looking at ordering a pair of these to fit a set of Supers. Not sure what length I need. They're going in a metal control panel, so am I correct in thinking that I need the shortest stick (1 1/4)? Why is it that the shiny ball tops only come in 1 3/8?

--- End quote ---

Just so there are no misconceptions, these are designed for under the panel installation on 1/2" to  7/8" thick material.  They can be used with metal, but a spacer will need to be installed ... unless you want really long joysticks :)  The shorter sticks are specifically for use with the Prodigy 4/8 way switchable joystick system.

The current ball top selection is basically what is available as stock product from manufacturers.  They are very nice ball tops, but the selection is a little limited on the shiny ones.

I have since had custom ball tops professionally manufactured that I'm sure a number of folks will find VERY interesting, but they will  be a bit more expensive than the stock offerings (in the $5 range).

Announcment soon.......;)

RandyT
jdjuggler:
I didn't see any comments regarding these sticks working with the P360's?
Anyone know?
Thanks,
JD
Stingray:

--- Quote from: RandyT on January 13, 2005, 10:09:09 am ---
--- Quote from: Stingray on January 13, 2005, 09:34:03 am ---I'm looking at ordering a pair of these to fit a set of Supers. Not sure what length I need. They're going in a metal control panel, so am I correct in thinking that I need the shortest stick (1 1/4)? Why is it that the shiny ball tops only come in 1 3/8?

--- End quote ---

Just so there are no misconceptions, these are designed for under the panel installation on 1/2" to
--- End quote ---
quarterback:

--- Quote from: Stingray on January 13, 2005, 09:34:03 am ---am I correct in thinking that I need the shortest stick (1 1/4)?
--- End quote ---

How do you figure that 1 1/4 is the shortest stick?  Aren't those measurement options (1-1/4, 1-1/2 & 1-3/8) referring to the size of the ball top?
Navigation
Message Index
Next page
Previous page

Go to full version