Main > Main Forum

New Product: Versa-Ball Joystick Replacement Shafts

Pages: << < (11/20) > >>

NoOne=NBA=:

RandyT,

I have the critical dimensions on the 49-way sticks.

The measurement from the top of the stick to the stepdown is exactly 4.25".
The larger diameter at the stepdown is .506".
The shaft diameter below the stepdown is .266".
The shaft length from the stepdown to the near edge of the E-clip is 2.53".

I only have the one stick to measure, so I am ASSUMING that Happs tolerances are fairly tight from stick to stick.

RandyT:


--- Quote from: NoOne=NBA= on November 29, 2004, 03:03:10 pm ---RandyT,

I have the critical dimensions on the 49-way sticks.

The measurement from the top of the stick to the stepdown is exactly 4.25".
The larger diameter at the stepdown is .506".
The shaft diameter below the stepdown is .266".
The shaft length from the stepdown to the near edge of the E-clip is 2.53".

I only have the one stick to measure, so I am ASSUMING that Happs tolerances are fairly tight from stick to stick.

--- End quote ---

Thanks NoOne!

I'll get something modeled up on those dimensions and see if my machinist can work in a few like this.   I'll let you know how I fare.  While I'm at it, I'll look into the P360's that I have recently aquired dimensions for.

Thanks again,
RandyT

Minwah:


--- Quote from: NoOne=NBA= on November 29, 2004, 03:03:10 pm ---RandyT,

I have the critical dimensions on the 49-way sticks.

The measurement from the top of the stick to the stepdown is exactly 4.25".
The larger diameter at the stepdown is .506".
The shaft diameter below the stepdown is .266".
The shaft length from the stepdown to the near edge of the E-clip is 2.53".

I only have the one stick to measure, so I am ASSUMING that Happs tolerances are fairly tight from stick to stick.

--- End quote ---

Do you know if Randy's style shaft without the stepdown will work with the 49-way?  It looks as though the actuator is too small for the shaft to fit through.  Having not (yet) taken mine apart I can't tell if the actuator comes apart or not...

RandyT:


--- Quote from: Minwah on November 29, 2004, 04:39:56 pm ---[Do you know if Randy's style shaft without the stepdown will work with the 49-way?  It looks as though the actuator is too small for the shaft to fit through.  Having not (yet) taken mine apart I can't tell if the actuator comes apart or not...

--- End quote ---

A stepdown will be required for the lower part.  These would require a special version made just for the 49-ways, but will most likely have the same diameter upper shaft and threads as the current ones.

On a side note, I may have a nicely fitting dust washer solution for an extra dollar if people need one.  The parts will be here in a day or two.


RandyT

NoOne=NBA=:


--- Quote from: Minwah on November 29, 2004, 04:39:56 pm ---Do you know if Randy's style shaft without the stepdown will work with the 49-way?
--- End quote ---


Pages: << < (11/20) > >>

Go to full version