Main > Main Forum

New Product: Versa-Ball Joystick Replacement Shafts

Pages: << < (10/20) > >>

RandyT:


--- Quote from: spiffyshoes on November 24, 2004, 06:55:52 pm ---Randy: The E-Clips on the Pac Man Revolution joysticks are 5cm apart and the shaft is 10mm thick.  From the end of the shaft to the bottom of the ball is about 8 cm total.  And the Diameter of the Ball is about 1-1/4" thick.

--- End quote ---

Excellent.  Thank you for the info spiffyshoes!

But just to clarify, are you referring to the Pac-Man Reunion / Galaga  joystick?

Thanks,
RandyT

spiffyshoes:

Yeah, the Pac Man reunion was the one I was talking about.

RandyT:


--- Quote from: spiffyshoes on November 25, 2004, 12:43:47 am ---Yeah, the Pac Man reunion was the one I was talking about.

--- End quote ---

Great.  Thanks.  :)

Based on this, I have high confidence that the Versa-Ball sticks will indeed work with the Pac Man Reunion/Galaga joysticks.  Both sets of grooves appear to be at the right places, which means installation in either 1/2" or 3/4"+  thick panels should be possible and would extend the height by about 4 cm in either setting.


I'll update the main post with this info.   

RandyT

pcates:

Randy do you have any that will fit a nintendo joystick? I have a stick for my Donkey Kong that was originally in a metal panel (too short). The stick is only 6mm thick. Can you help???

Patrick

RandyT:


--- Quote from: pcates on November 25, 2004, 01:28:37 am ---Randy do you have any that will fit a nintendo joystick? I have a stick for my Donkey Kong that was originally in a metal panel (too short). The stick is only 6mm thick. Can you help???

--- End quote ---

Sorry Patrick,

I'd like to help, but I don't think the demand would be very high for these.  At best it would be a one-off situation and probably pretty costly to do.

You might want to consider just replacing the whole stick.  Could be a better solution in the long run.

RandyT

Pages: << < (10/20) > >>

Go to full version