| Main > Main Forum |
| Would this fit? |
| << < (2/2) |
| AlanS17:
I was expecting to remove the casing anyways. I'm glad to hear that everything stays intact, though. Would I have to enlarge the cut-out where the monitor shows through? |
| paigeoliver:
--- Quote from: AlanS17 on November 12, 2004, 03:24:13 pm ---I was expecting to remove the casing anyways. I'm glad to hear that everything stays intact, though. Would I have to enlarge the cut-out where the monitor shows through? --- End quote --- Not sure, I didn't fully investigate it, I just measured it up real quick. If you did have to enlarge it, then it wouldn't be by much, as the tube on the KDS is just BARELY bigger than the tube on a 19" G07 monitor. |
| AlanS17:
Well enlarging a little or a lot probably requires the same amount of effort (and more importantly, the same room for mistake). Any expansion at all kind of turns me off to the idea. |
| fredster:
Yes, it will fit. It's tight, but it will fit Horizontally. Vertically, you may have to knock out the back plate and move it. |
| Navigation |
| Message Index |
| Previous page |