Main > Main Forum

Newbie needs help

Pages: << < (8/9) > >>

RayB:

No prob, though I did get exasperated a bit. Sorry about that.
I realize it's difficult to find something that isn't there!  ;D

Marky_1979:

Got my parts now but cant get them to attach need to know if anyone has used this happs type before and can assist

IMMark:

Sounds like you have been having quite a time....I take it from previous posts..that the parts you have receive ed and trying to put on ; is the micro switch for the coin mech???   If so, what exactly is the prob....screw holes don't line up?   Wire won't fit in slot?   If that is not the part you are talking about...please give specifics.

Marky_1979:

I followed what Ray said and was up last night for 3 hours trying different ways of fitting it but no luck :( do you think it might fit as part of the coin mech holder? cant think of any other things? parts are correct as from same place i asked them for the bits i need.

Yes it has been tricky definately not the simple job i thought it was gonna be.

IMMark:

Well, I hope I understand what you are after....
The following picture is a coin mech with switch in place.
Please be as detailed as possible to what you want to do, what problems you are having....(ie screw holes don't line up, wire doesn't fit slot....???)
Is the wire on your switch straight or bent on angle???

Pages: << < (8/9) > >>

Go to full version