Main > Main Forum

Happ Highball Trackball Lip problem?

Pages: << < (2/2)

rdagger:

I used a router with a chamfer bit to route the Lexan to the diameter of the lip with a bevel so the lip is flush with the Lexan.

ras2a:


--- Quote from: rdagger on November 09, 2004, 09:52:56 pm ---I used a router with a chamfer bit to route the Lexan to the diameter of the lip with a bevel so the lip is flush with the Lexan.

--- End quote ---

cool idea rdagger - cheers...methinx that will give the best finish!..will have to see if i have a bullnose bit etc

Also thanks Whammoed, I haven't actually measure the lip, but if it does 'protrude' that far (nearly 4mm) then that should be great.  Feel a bit of an idiot now - doh!

Pages: << < (2/2)

Go to full version