Main > Main Forum
Happ Highball Trackball Lip problem?
<< < (2/2)
rdagger:
I used a router with a chamfer bit to route the Lexan to the diameter of the lip with a bevel so the lip is flush with the Lexan.
ras2a:

--- Quote from: rdagger on November 09, 2004, 09:52:56 pm ---I used a router with a chamfer bit to route the Lexan to the diameter of the lip with a bevel so the lip is flush with the Lexan.

--- End quote ---

cool idea rdagger - cheers...methinx that will give the best finish!..will have to see if i have a bullnose bit etc

Also thanks Whammoed, I haven't actually measure the lip, but if it does 'protrude' that far (nearly 4mm) then that should be great.  Feel a bit of an idiot now - doh!
Navigation
Message Index
Previous page

Go to full version