Main > Main Forum
Powering your cabinet
danny_galaga:
a view from inside...
there is probably a version that allows this sort of mounting properly. like i say, i took it off something else. just remembered, it was from the monitor IN the cab. nothing like recycling the bits :D. it was flush mounted to the pcb. you would just need one that is designed to point UP from the pcb.
edit: a dead power supply might have the right shape...
Craig:
Thanks for the reply. I am impressed by your safe wiring by using heatshrink tubing etc. ;-)
danny_galaga:
the wires to the right go to some microswitches for the rotating monitor. even with the heatshrink i STILL managed to get zapped a few times adjusting them!!
paigeoliver:
--- Quote from: danny_galaga on November 08, 2004, 12:00:39 am ---used one of these. forgotten what it was from, a dead monitor or something. i had to make the hole a bit bigger to fit it though but underneath a cocktail it doesnt matter
--- End quote ---
I have actually started modifiying my real cabinets this way. Whenever I need to replace a cord I do it that way now. Makes it so much easier to deal with.