| Main > Main Forum |
| Help: T-Molding Bit In Canada. |
| (1/3) > >> |
| Demon-Seed:
Hello I am finally going to buy a t-molding bit. I am in Canada and have no clue what to get... I checked t-molding.com and in the installation tools section they have a bit that looks correct, and they say it works. 3 Wing Slot Cutter Assembly - 1/16" Slot #38 Is this what i need for my router to install tmolding? If so where in canada can i get it.. 27$ usa is a bit (ehhe a bit get it) steep for me.. anyone advise? i need it asap! thx JIM |
| Oldskool:
http://www.1blades.com/ They're in Saskatchewan, and very reasonable. |
| Jabba:
I bought a Freud 1/16th slot cutting bit at Home Depot. I had to special order it and it took a week to come in, but you know what...No Duty, No Shipping Fees, etc. You will also need to buy a 1/4" shaft to hold the slot cutter if you do not have one already. I forgot what it cost, but I know it was cheaper than ordering. Good Luck! |
| Grauwulf:
You don't say where in Ontario you are, but if you're in the GTA, there is a hardware place in a strip mall at Derry and Tomken in Mississauga that is a Freud dealer. Freud's Canada office/warehouse is about two blocks away on Pacific. You pay for the bit at the hardware store and then drive over to the warehouse to pick it up. That's what I did. |
| menace:
Grauwulf--How much was it at the strip mall place you went to? Can you recall the name of the store? |
| Navigation |
| Message Index |
| Next page |