Main > Main Forum

What could I use for microswitches instead of soldering

Pages: << < (2/3) > >>

blueoakleyz:

No shipping cost?

Tiger-Heli:


--- Quote from: blueoakleyz on October 27, 2004, 01:05:56 am ---I'd solder to the PCB of course, but to make less of a mess of things,

Where I'd stick the wire in to one end/solder it to the sleeve and then stick it to the microswitch prong

--- End quote ---
If using a I-PAC or KeyWiz, there are screw terminals, so no soldering to the PCB either.

No soldering to the sleeve unless you want to.  (They're crimp-on connectors).

SirPeale:


--- Quote from: blueoakleyz on October 27, 2004, 01:59:47 am ---No shipping cost?

--- End quote ---

Free shipping!

Ken Layton:

All modern commercial arcade games use crimp-on quick disconnect female .187 (a.k.a. 3/16") terminals. This is exactly how how build (and repair) control panels is with quick disconnects.

Bob Roberts has a crimping tutorial on his website.

HaRuMaN:

BUY FROM PEALE!!!  :D

You can't beat the price  (6$ shipped for 100!) and he gets em to you quick!  :)

Pages: << < (2/3) > >>

Go to full version