| Main > Main Forum |
| Trying to interface Interact Gas Pedals with Arcade |
| << < (2/2) |
| Trimoor:
--- Quote ---Can't you just recalibrate in windows? --- End quote --- If I remember properly, the Dreamcast doesn't use windows! 8) |
| u_rebelscum:
--- Quote from: Trimoor on October 11, 2004, 04:44:50 am --- --- Quote ---Can't you just recalibrate in windows? --- End quote --- If I remember properly, the Dreamcast doesn't use windows! 8) --- End quote --- D'oh! I was somewhere else when I wrote that. :-[ AKAIK (and it's not that much): a) dreamcast calibrates the center on bootup b) IIRC, each pedal should output a range of ~2.5 volts (2.3v should be enough); I think one does ~ 0.2-2.5, the other ~ 2.5-4.8. I don't know the supplied current, but V = I * R. "The rest is left as an exerise for the student." A couple things to note: since it's calibrated at bootup, the center volts can be other than 2.5, but the ends still need to be ~0.2v and ~4.8v. Also, I'm basing this off a couple different gamepads; the dreamcast pedals might be different (but I doubt it). |
| Navigation |
| Message Index |
| Previous page |