Main > Main Forum
Trying to interface Interact Gas Pedals with Arcade
(1/2) > >>
JackTucky:
I have an outrun cabinet that has the "origjnal" gas and brake pedals.    I'm putting a dreamcast in the cab for racing games.  I want to interface the pedals that came with the DC steering wheel.

The DC pedals insides look like this:



The arcade pedals insides look like this:



I've got the wires where they are supposed to be, gas works fine, brake even kind of works, but the brake light on 4x4 evo is always on.  When I DO hit the brake, it does stop and then go into reverse, which is what it does when I use the DC pedals.

I'm guessing that the Pots have different values or something?  maybe move the brake pot a little?  Anyone know what to do to make it work?

Thanks in advance.

Art
JackTucky:
Hey, take the gears off of the pot, then move the pot so it doesn't brake, then put the gear back on.

Done.

Thanks!

 ::)

JackTucky:
I've got it setup so the pots start at zero, but i can't press the gas enough now.  Should I replace the pots from the DC controller into the arcade one, or what?  Thanks

pcates:

--- Quote from: JackTucky on October 08, 2004, 10:49:10 pm ---I've got it setup so the pots start at zero, but i can't press the gas enough now.  Should I replace the pots from the DC controller into the arcade one, or what?  Thanks
--- End quote ---
I would try to switch them out. I think the arcade ones are 5K, and the DC may be 100, so there would be a big difference. If they dont fit they may have some at radio shack. Good luck...

P.S. Did you stuff that 21" monitor in yet??
u_rebelscum:

--- Quote from: JackTucky on October 08, 2004, 10:49:10 pm ---I've got it setup so the pots start at zero, but i can't press the gas enough now.  Should I replace the pots from the DC controller into the arcade one, or what?  Thanks
--- End quote ---

Can't you just recalibrate in windows?
Navigation
Message Index
Next page

Go to full version