Main > Main Forum
Major Havoc roller repro - need input
XtraSmiley:
--- Quote from: mahuti on September 18, 2004, 10:09:13 am ---All I know is that I'm in if the cost is around $100 or below.
--- End quote ---
froggerman:
--- Quote from: Tommy Boy on September 18, 2004, 12:35:08 pm ---I'm curious, are there any other games (besides MH) that this control would be useful for?
--- End quote ---
Here is what I found at the controls.dat website:
Roller(Horizontal)
Major Havoc (rev 3) mhavoc
Moonwar moonwar
Kick (upright) kick
OSCAR:
A friend of mine stopped by with a Kick controller so I could install one of my optic boards on it. It looks like a trackball, but it is only single axis. It has an axle that goes right through the ball, so it acts exactly like a roller.
Also, to better help explain the "ears" thing, I uploaded a couple screenshots of my 3D part model. That should explain it better than the lousy shop drawings.
http://www.oscarcontrols.com/mhavoc/model3d-1.gif
http://www.oscarcontrols.com/mhavoc/model3d-2.gif
spidermonkey:
Yeh you're thinking of "Moonwar" Telengard. I played it at Funspot too. The roller on that game is like the size of a hockey puck on edge or even a bit bigger. It could probably be played with a M.H. controller if the sensitivity was turned up to compensate for the smaller roller. Same with "Kickman"
Generic Eric:
--- Quote from: OSCAR on September 18, 2004, 06:16:53 pm ---A friend of mine stopped by with a Kick controller so I could install one of my optic boards on it. It looks like a trackball, but it is only single axis. It has an axle that goes right through the ball, so it acts exactly like a roller.
Also, to better help explain the "ears" thing, I uploaded a couple screenshots of my 3D part model. That should explain it better than the lousy shop drawings.
http://www.oscarcontrols.com/mhavoc/model3d-1.gif
http://www.oscarcontrols.com/mhavoc/model3d-2.gif
--- End quote ---
Ok, now I am with you. Looks like a solid product.