Main > Main Forum
Where to get 1/16" slot cutter router bit????
megashock5:
Hello, I'm building a cabinet from the Project Arcade book. It says to use a 3/32" slot cutter router bit, but both tmolding.com and groovygamergear say that their molding uses 1/16".
The problem is I can find slot cutter bits anywhere around here. The book says there is a list of sources for the bit on the accompanying CD, but the list is all for controls - no listing for router bits like it claims.
Any suggestions? Where have you guys found these?
thanks!
pointdablame:
http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_slot.html
3 wing slot cutter. width of cut - 1/16". Buy the complet set unless you have the arbor and bearing already.
Tailgunner:
I ordered mine through Lowe's. They carry Bosch router bits and can get the slot cutters. I ordered both a 1/16" and a 5/32" cutter and a single arbor. So far I've used the 5/32" more because the T-molding I have fits it better.
okmike87:
Has anyone had any experience with the t-molding from www.dreamarcades.com?
If so, what size slot cutter should I use to install it?
Mike
megashock5:
Tailgunner, do you remember how much the 1/16" slot cutter was through Lowes? I have a couple fairly close.
The link in the post before yours has them for $16 including for the whole thing and $12 for just the blade part.
thanks!