| Main > Main Forum |
| Help Restoring Dynamo Cab |
| (1/3) > >> |
| brained:
Hi all, I recently bought an used empty Dynamo Cab and I have a couple of questions: 1) The back left side of my cab has grown a little due to water damage, it's 3/4 particle board and it grew to 1 1/2 inch thick. But just the back part of the Cab. The front Is ok!. I've seen some people that use bondo to fix this issue. What shall I do??? If there any ways I can save that without replacing the board??? 2) My cab is covered with black rugged vinyl, on the inside and the outside. should I paint the cab??, or remove the old vinyl and apply some new one. What about the inside part... If I want to replace the ones inside I need to dismantle the side boards, I think Please give me some light, and suggestions!!, I'll post pictures of the first question when I get home from work. |
| metahugh:
I have a Dynamo cab in the same condition, the sides appear to have quite a bit of water damage. They have expanded at the edges. It appears to have some type of thin paper like covering that is coming off. Since it's particle board underneath I felt that painting would be a pain, plus the sides would get damaged easier. I am going to purchase the roll of adhesive vinyl that Happ sells and cover the sides. Will same me quite a bit of time and will be more resistant to bumps and bruises. http://www.happcontrols.com/vending/acesor/49057200.htm If you want to purchase the vinyl from the link I provided just wait a second and the rest of the page frames will come up giving you the purchase links. --- Quote from: brained on September 02, 2004, 10:24:10 am ---Hi all, I recently bought an used empty Dynamo Cab and I have a couple of questions: 1) The back left side of my cab has grown a little due to water damage, it's 3/4 particle board and it grew to 1 1/2 inch thick. But just the back part of the Cab. The front Is ok!. I've seen some people that use bondo to fix this issue. What shall I do??? If there any ways I can save that without replacing the board??? 2) My cab is covered with black rugged vinyl, on the inside and the outside. should I paint the cab??, or remove the old vinyl and apply some new one. What about the inside part... If I want to replace the ones inside I need to dismantle the side boards, I think Please give me some light, and suggestions!!, I'll post pictures of the first question when I get home from work. --- End quote --- |
| MAME nut:
I had water damage on the bottom 2" of my cabinet. I simply cut it off, put a new bottom on, and then installed wheels to make up for the difference. |
| Tailgunner:
My Dynamo cab was in similar shape. Here's what I did to fix it. http://www.arcadecontrols.org/yabbse/index.php?board=10;action=display;threadid=12414 |
| brained:
Tailgunner, you did a Helluva job there NICE!!!!. But i think my back panels are a wider than yours, but anyways I can just sand it down and then bondo right??? Ohh can u show me the Control Panel, I wanna see it. Ohhh should I dismantle the side panels and apply new vinyl to them on the insides.?? |
| Navigation |
| Message Index |
| Next page |