Main > Main Forum
LuSiD has me pulling my hair out!
Bill Mote:
:-[
Should have searched. Sorry. Knee-jerk reaction to my frustration. At least I'm not crazy ... errr ... as crazy as I thought I was.
dot
SteveJ34:
--- Quote from: dot on August 31, 2004, 08:29:19 am ---OK, so I'm building my 1st MAME cabinet. YEAH! :-* I'm using both the "Project Arcade" book, the information on-line at LuSiD's site and the many, many, many helpful posts in the forums.
Here's my problem. There just isn't enough wood in 3 sheets of 3/4" MDF to build LuSiD's design. His cabinet is 6'2" tall, but his "back" boards are a whopping 36" in total -- 26" wide and 18" tall each for the top and bottom section. I finally figured out that the drawings don't account for the 3-1/8" the sides sit below the "real" bottom (inside) on the cabinet. The angled top takes off some, but I'm still left with ~55" of cabinet back to cover.
Am I missing something?!
dot
--- End quote ---
I used Lusid's plans with a few modifications.
It's been quite awhile since I did the construction but revisiting the PDF documents just now it does appear the design does not include covering the entire back. I seem to recall this was the situation and I ended up getting an extra sheet of MDF. I built mine out of 5/8" and used 1x2 stringers, wood glued, and counter sink screws for attaching sides to top, bottom, back, etc.
I think I also used 2x4s under base support rather than the MDF stringers the design plan calls for.
My back has about an 18 inch piece on top, 18-22" on the bottom, and then I made a single piece that drops in between. I attached a 1x2 stringer on the inside of the top piece and a 1x2 stringer on the inside of the insert piece and keylock on the top of the insert piece.
In this way the large section can be removed.
I've never had a problem with heat....I added chrome soffet vents on the angled piece on top.
That's what I did, hope the above helps.
Steve
DougHillman:
In the cabs I build, I'm using 1/4" hardboard (sorta like pegboard material without the holes) for the back inserts. Saves alot of weight and hassle if you've gotta remove them. Costs less too.
Jakobud:
I'm not sure if it will help you guys or not, but take a look on my website for my LuSid cabinet plans that I drew up. They might help shed some light on certain aspects of the construction that are unclear in LuSids original plans.
Bill Mote:
Y
O
U
A
R
E
A
S
T
U
D
!
Holy cow those are nice. Why in the heck didn't they include that detail in the book?! Do you have that level of detailed for your control panel?
dot