Main > Main Forum

i feel foolish to ask this :p how do u crimp the quick connects?

Pages: (1/2) > >>

apu95:


as the title says, i feel foolish to ask this, as when i find out itll prolly be so obvious :D

anyways, i ordered the ipac2 from ultimarc and also the wiring kit that comes along with it (look at pic to see the tool).
i cant figure out how to crimp the quick disconnects on to the wires that were provided with the kit.

thx again,
Apu

itismejs:

Stick a wire in the quick disconnect hole and then squeeze it shut w/ the crimping tool....(use the  part with the red dot on it.

pocketbikez:



i use the back part of the tool for some leverage.

paigeoliver:

I feel more foolish, I have been doing this for years and I have been using this part.


exibar:

You both are right actually!  :-)

  The top part of the tool with the Red, Blue, and Yellow Dots are for Insulated connectors.  The back part of the tool is for NON-Insulated connectors.

  If you crimp an insulated connector with the non-insulated part, it will still work, but you'll stand a change of destroying your plastic insulation.

  Mike B

Pages: (1/2) > >>

Go to full version