| Main > Main Forum |
| ILMech BYOAC token adjustment |
| (1/1) |
| rchadd:
help! i've just tried to adjust my ILMech to take the BYOAC tokens as shown at http://www.miavio.com/HappILMech.htm but i've taken slightly too much off! it now rejects every token :'( any suggestions on best way get it working? i'm wondering if i can glue the L swing arm in place? but not sure if that would work alternatively is it possible to adjust the ILmech to accept all coins? |
| rchadd:
i've just noticed that if i tilt the mech back slightly the coins are accepted. i am wondering if there is another adjustment i can make? |
| rchadd:
i think i have fixed it ;) i figured out that the tokens were being rejected at the magnet check. as i am not worried about this check i simply applied some tape over the reject slot to force the coin into the accept slot. its accepting all tokens now! |
| Navigation |
| Message Index |