| Main > Main Forum |
| Plywood Load bearing |
| (1/3) > >> |
| shadowdrak:
What is the reason people build their cabs with 3/4 inch wood? This is the most common type I see. Is it because it is the type used in most authentic cabs, or is it because it is required for holding the weight? My dad seems to think it is a bit overkill, but he is just good with tools -- not a carpenter. Also, has anyone had any experience using offset t-molding on the control panel( so the long side overhangs the plexi)? |
| skid_68:
Personally Im using 3/4 MDF because Lowes, and Home Depot didnt have 5/8 MDF. So meh..... |
| JustMichael:
--- Quote ---What is the reason people build their cabs with 3/4 inch wood? --- End quote --- Plywood makes for a lighter cabinet. Some people who finish their cabinet as furniture use it because of the wood finish. --- Quote ---Is it because it is the type used in most authentic cabs, or is it because it is required for holding the weight? --- End quote --- Almost all cabinets I have seen are made from MDF. 3/4" provides a nice strong shell. Remember arcade cabinets are built to take abuse. |
| pointdablame:
For one, like was mentioned, 5/8 wood is a bit harder to find. My opinion is that the 3/4 is used because it requires minimal framing. If you and your dad built a complete frame and shell out of 2x4 or the like, you could easily tack on 1/2" wood since that would be more a covering than an actual side. If, however, you'd like to just use some ledgers to attach pieces together without having to build an all out skeleton, 3/4 is the better way to go. |
| paigeoliver:
--- Quote from: JustMichael on August 21, 2004, 05:33:55 pm --- Almost all cabinets I have seen are made from MDF. 3/4" provides a nice strong shell. Remember arcade cabinets are built to take abuse. --- End quote --- That would be almost all scratchbuilt cabinets. I have owned well over 100 factory made arcade cabinets and not a single one of them was made out of MDF. In fact I am still unaware of an MDF cabinet ever being made by a real arcade manufacturer, unless Dynamo uses MDF now? |
| Navigation |
| Message Index |
| Next page |