Main > Main Forum
My tmoulding question......... :(
<< < (2/3) > >>
rdagger:
You could always fill the slot with wood putty and try again with a smaller bit.  I just repaired a small section where I cut the slot to wide using putty and it worked well.  You probably want to wear long sleeves because the routing debree from the putty is heavy and hurts if it hits your arm.
Excretious:
Thats what i'll do then, thanks for all your help!


 :D ;D :D ;D :D ;D
DougHillman:
Personally, I'd just glue it.  it's not going to look any different from the outside.  And it's gonna be quite a bit more of a pain in the ass to fill, sand and rerout the whole thing.  

Trimoor:
If you're going to glue it, use exopy.

Much stronger than hot glue.

You can get it in two types:
One that sets in 5 minutes and dries soilid in an hour,
or one that sets in a few hours and dries in a few days.
RayB:
Hot glue hardens too fast... I suppose you could do it, but you gotta be quick and efficient.

Navigation
Message Index
Next page
Previous page

Go to full version