| Main > Main Forum |
| Will this Router Bit work? |
| << < (5/7) > >> |
| rdagger:
--- Quote from: enchntr on August 13, 2004, 04:51:13 pm ---I used a good utility knife and notched the inside and outside corners. Worked flawlessly. Ed --- End quote --- Could you explain how the notches should be cut? |
| marsmarvin:
--- Quote ---Could you explain how the notches should be cut?" --- End quote --- Spystyle has a good explaination with pictures about 2/3rds down this page: http://spystyle.arcadecontrols.com/index4.htm |
| marsmarvin:
By the way, I said last week that I'll need glue with the 3/32 inch slot, but I was wrong. It turns out that after painting, 3/32 is not too big afterall. Sorry I doubted Saint. |
| atog:
yep basically how it's shown in that picture, just remove some of the slot in the area where it has to bend around the corner. |
| RacerX:
--- Quote from: reebboy on August 12, 2004, 09:12:43 pm ---Here is the direct link to the 3 wing slot cutters on mlcs. This is the best deal in town. They don't charge for shipping in the USA either. http://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bt_slot.html --- End quote --- I also ordered my slot cutter from MLCS, and I was very pleased with the speed of shipping. I can't recommend them enough. |
| Navigation |
| Message Index |
| Next page |
| Previous page |