Main > Main Forum
Will this Router Bit work?
(1/7) > >>
the3eyedblindman:
I have been searching high and low for a router bit for the T molding and I came across a 1/8 inch slot cutter, now this would be 4/32 inch bit, and I believe the book (Project Arcade)  says to use a 3/32 inch bit. How much can 1/32 of an inch difference be, thats like a grain of salt, so can I use this bit? I really need a reply soon.
Bgnome:
i believe the standard bit everyone uses is 1/16th.  anyone that has used the 1/8" slot cutting bit has found that they need to use hot glue to keep the t-molding in.
Apollo:
Ditto, hot glue gun will do the trick.
the3eyedblindman:
No, I would rather just get the right bit, anyone have one or know where i can get one? I dont really wanna have to catalog order at home depot, would just like to pick one up.
lindart:
mlcswoodworking.com has them for $16 shipped.
Navigation
Message Index
Next page

Go to full version