| Main > Main Forum |
| Advice Needed:Keyboard Encoder for Very Simple CP |
| (1/1) |
| NinjaEpisode:
So the first cab I'm going to build, to keep it simple on myself, prove to myself I can do it, and to prove to the wife that it's pretty cool, is a smaller Pac Cab. Since I'm looking at basically a single 4-way joy, 1 & 2 player button, and a coin-up interface, am I better off just doing a keyboard hack, or should I spend the money on a minipac or ipac? The intent would be to run ArcadeOS in a DOS interface and have the cab dedicated to Pacman itself, so I don't need a huge keyboard interface... What would you do? |
| Bgnome:
personally, i would go with a keyboard hack since soldering is easy for me and you will only be using 2 or 3 simultaneous inputs at most. plus the fact that i have an extra keyboard lying around helps.. gamepad hacks are a possibility also, but for DOS, you will most likely be looking for gameport ones with drivers, which may be more trouble than it's worth. you "could" go ahead and get a dedicated encoder, but i think it would be overkill for a project like this and would try to avoid it unless you are deathly afraid of soldering and dont know anyone iwlling to do it for you.. |
| SirPeale:
Yeah, hack a KB. Practice soldering first on scrap. |
| NinjaEpisode:
Welp, I'm all for the keyboard hack. Worst case scenario, I fry a few keyboards working it out.... |
| Tiger-Heli:
--- Quote from: NinjaEpisode on August 11, 2004, 08:39:03 am ---So the first cab I'm going to build, to keep it simple on myself, prove to myself I can do it, and to prove to the wife that it's pretty cool, is a smaller Pac Cab. Since I'm looking at basically a single 4-way joy, 1 & 2 player button, and a coin-up interface, am I better off just doing a keyboard hack, or should I spend the money on a minipac or ipac? The intent would be to run ArcadeOS in a DOS interface and have the cab dedicated to Pacman itself, so I don't need a huge keyboard interface... What would you do? --- End quote --- A keyboard hack would work fine for this (assuming you don't make really bad choices on inputs). Considerations for an I-PAC/2 or KeyWiz (or KeyWiz ECO) (www.groovygamegear.com) - these might be a better option if: - You may use emulators which don't allow re-mapping of key assignments - - You don't like soldering (avoid the ECO, then) - You will be building or improving your cab later and will need the I-PAC/KeyWiz then - You want to save time and be sure the keyboard interface part of the project works. |
| Navigation |
| Message Index |