| Main > Main Forum |
| Adhesive on Control Panel overlay from mamemarquees |
| << < (2/3) > >> |
| walls83:
Just give it a light coat... What I mean by dont over do it is your need to realize that this is glue. and if you have a spot where you just glob it on its going to act just like glue in a bottle if you globbed it on. Just give it a light coat, get the edges and your good to go.. Its not hard to use. |
| Sylentwulf:
Just bought some (I'm impatient, and this is the part I've been looking forward to) I got the 3m Spray Adhesive 45. They had 4 levels of adhesive, I bought the lowest (and MUCH cheaperest) Hopgint hat's ok? |
| AGGIEZ:
--- Quote from: Sylentwulf on August 03, 2004, 09:48:56 pm ---Just bought some (I'm impatient, and this is the part I've been looking forward to) I got the 3m Spray Adhesive 45. They had 4 levels of adhesive, I bought the lowest (and MUCH cheaperest) Hopgint hat's ok? --- End quote --- Let us know how it goes. I have a CPO coming form mamemarquees and I guess I'll probably have to do the same thing... |
| Sylentwulf:
Well, I THINK My problem might have been one of the following (if it helps ya any) Latex paint - I think I'd have been better off just priming (or not even priming) the MDF Soap/Water mixture - I dunno, without it, there's NO WAY I would have gotten this thing centered and lined up right, must have taken 20-30 tries. Time - I got the CPO about a month ago, and just applied it today, I stored it well, but it still could have affected it. It's coming out ok, the spray adhesive worked great, but it's still bubbling up some around the buttons when I install them. I wish I'd have been able to find 5/8" MDF and used plexi..... |
| Santoro:
I am going from my bad memory here, but I thought that I read on mamemarquees.com that you shouldn't use the 'wet' method with his products. FWIW |
| Navigation |
| Message Index |
| Next page |
| Previous page |